Video
Fuel level sensors
Different fuel types (summer diesel, winter diesel and especially biodiesel) have different permittivity values. DUT-E 2Bio fuel level sensor is designed for accurate volume measurement of all types or fuel. Re-calibration and re-configurations is not needed.
Integrated solution for real time tracking and fuel monitoring.
The advantages and features of the DUT-E fuel level sensor. – Filter screen: protection from water and mud. – Spring catch: safe mounting. – Length increase up to 6000 mm. – Signal summation.
What happens with DUT-E 2Bio when adding a liquid with high dielectric conductivity? Watch this video to find out!
Fuel level sensor installation into fuel tank with thin walls using rivets. Installation kit includes items for three variants of installation. We recommend to use threaded rivets for installation of DUT-E into fuel tank with thin walls (1-2mm).
1. Loosen screws and remove head cap of sensor
2. Slide cover of Micro SIM card holder and open it
3. Insert Micro SIM card
4. Close the cover of Micro SIM card holder and slide to lock position
5. Evenly fill the space around frame of Micro SIM card holder with sealant.
DUT-E fuel level sensor is well protected against short circuit. The filter screen only lets diesel in, guarding the sensor from water and dirt in the vehicle tank. Check it out!
In the video you can see the whole process of DUT-E installation: mounting and setup of the fuel level sensor, as well as tank calibration.
Fuel Flow Meters
This video demonstrates how to install DFM fuel flow meter after the fuel pump.
Fuel Flow Meter DFM amazing sensibility in experiment by Technoton.
– The advantages and features of the DFM fuel flow meter
– Direct fuel consumption measurement
– Accurate measurement on rough terrain
– Accurate measurement on rough terrain
– Engine operation time monitoring
Contactless readers
– Safe CAN bus data collection
– Safe J1708 bus data collection
– Petrol and gas monitoring
– Vehicle operation data transmission over GPS telematics terminal
Here’s a video by Technoton on how to correctly open and close the “jaw” of the Crocodile contactless readers.
1. Loosen screws and remove head cap of sensor
2. Slide cover of Micro SIM card holder and open it
3. Insert Micro SIM card
4. Close the cover of Micro SIM card holder and slide to lock position
5. Evenly fill the space around frame of Micro SIM card holder with sealant.
Axle Load Sensors
GNOM DP is designed for monitoring axle load on vehicles with leaf spring suspension.
S6 Telematics Interface
S6 is a SAE J1939 based system of cables and protocols designed to collect information from external sensors or peripheral devices in conjunction with data acquisition of one or more vehicle CAN buses.
Таймер питания
Protection of on-board equipment against interference in vehicle electrical system Ensuring 24/7 power-supply
